|DESCRIPTION OF ENHANCEMENTS
This patch fixes several NOIS and FORUM mail message problems.
by killing %ZISQUIT after each try.
NOIS SAT-0196-71702 The number of characters on the task number that were
included in the VMS name was to small for the current task numbers at some
sites. This has been fixed in %ZTMS3 to allow more characters in the name.
NOIS BRX-0196-10212 The executable help for the related frame subfield
of the Help frame file has bad code in it that prevents its use. The
code has been commented out. (sent as a partial DD for file 9.2)
'IO/%ZTIO MM' TaskMan errors, This was used to confirm and understand an
issue. The problem is understood and there isn't an need for the entry in
the error log. It has been removed from ZTMS2.
Forum # 17283911 On this message it was agreed that IO should be restored
if POP was returned with a non-zero value. It currently is returned as 'NULL'
in this case. This has been fixed.
Forum # 18837345 The help display of printers was impacted by a screen
%ZIS("S") that changed the naked. This did not follow SAC guidelines,
NOIS HOT-0196-40372 When displaying the $JOB number in XUS91, if the number was
and has been fixed in ZIS5.
The OPEN/USE/CLOSE ^%ZISUTL calls didn't work. This has been fixed in
ZISUTL and ZIS1. The setting of IO(0) was changed to only happen one time
so that IO(0) should always point to the HOME device, fixed in ZIS.
Hans found that the taskman resource logging was not being done. The fix
was found in XUTMG43. To make the sorting of taskman work consistent
the resource log string was changed in %ZTMS and %ZTMS3
greater than 127 it was converted to a HEX value needed by DSM sites. This
I was found that the order of event during error traping needed improvment.
also requested was a hang to allow IO ports to reset during errors. This
has been done in %ZTMS.
routine new checksum
caused problems with the newer versions of MSM that can have $JOB values greater
than 127. This has been changed to check for values greater than 32768.
1. Use the 'INSTALL/CHECK MESSAGE' option on the PackMan menu. This
option will load the KIDS package in this message onto your system.
2. Answer NO to the question:
'Shall I preserve what is on disk in a separate back-up message ?'
3. From the 'Installation Menu' of the KIDS menu, run the option
'Verify Checksums in Transport Global' and verify that all routines
have the correct checksum.
4. Inhibit users from login into system.
5. From the 'Installation Menu' of the KIDS menu, run the option 'Install
Package(s)' Select the package 'XU*8.0*18' and proceed with install.
6. After installing this patch, you need to move several routines from
your productions account to the manager account:
NOIS DAY-1295-41565 In %ZIS3 the use of %ZISQUIT in a hunt group would cause
and in the manager account rename
ZIS to %ZIS
ZIS1 to %ZIS1
ZIS3 to %ZIS3
ZIS5 to %ZIS5
ZISUTL to %ZISUTL
ZTER to %ZTER
the complete hunt group to fail, not the one entry. This has been fixed
ZTER1 to %ZTER1
ZTMS to %ZTMS
ZTMS2 to %ZTMS2
ZTMS3 to %ZTMS3
Example: ZL ZOSVVXD ZS %ZOSV
7. On MSM move the routines to the other servers.
On DSM, rebuild your map set.
9. Enable user's login.