| DESCRIPTION OF ENHANCEMENTS |
NOIS Calls: LAS-1000-62717
to .5 just before the call to the RPC. This was done because the code to set
up the user at the remote site wasn't ready. When the code was fixed to
properly set the DUZ, the old code was never removed. This has been fixed
in the routine XWB2HL7. If data was left in the ^XUTL("XQ",$J,"IO")node it
could cause problems when HOME^%ZIS is called by some RPC's, so this ^XUTL
node is killed off before the RPC is called.
In a E-mail message from CPRS developers: The global that may be used to
pass data back to the RPC was not killed before its use. This was fixed in
the routine XWBDRPC.
BOI-1000-52970
Routine Summary
The following routines are included in this patch. The second line of each
of these routines now looks like:
;;1.1;RPC BROKER;<patchlist>;Mar 28, 1997
Checksum
Routine Old New 2nd Line
XWB2HL7 9756388 9762168 **12,18,20**
XWBDRPC 4972286 5069845 **12,20**
LOM-1200-62234
List of preceding patches: 12, 18
Sites should use CHECK^XTSUMBLD to verify checksums.
=========================================================================
Installation:
1. Do not run any RPC-Broker-based Remote Data View software
(e.g., CPRS, PCMM) during the installation. Do not allow any
incoming HL7 RDV messages. To identify these jobs, check the
ANN-1200-41924
system status and verify if any XWBTCPC routines are running
(i.e., Broker Handler). Once identified, notify users to logoff
or forcex the jobs. Active users may get NOSOURCE or CLOBBER
error messages .
2. Stop the Broker Listener on the server. Check the system status
and verify if the XWBTCPL routine is running (i.e., Broker
Listener). If it is running stop it. To stop the Listener, do the
following:
WRJ-1100-11904
a. Log into your M server.
b. Enter the following at the M prompt:
>D STOP^XWBTCP(Listener port)
(Typically, the Listener port is 9200)
3. Broker routines are not usually mapped on systems that allow it, so
you will probably not have to disable mapping.
4. Use the 'INSTALL/CHECK MESSAGE' option on the PackMan menu. This
BEC-1100-20841
option will load the KIDS package onto your system.
5. The patch has now been loaded into a Transport global on your
system. You now need to use KIDS to install the Transport global.
On the KIDS menu, under the 'Installation' menu, use the following
options:
Verify Checksums in Transport Global
Print Transport Global
Compare Transport Global to Current System
Backup a Transport Global
6. On the KIDS menu, under the 'Installation' menu, use the following
option:
Install Package(s) 'XWB*1.1*20'
==========
No Options or Protocols need to be placed out-of-order.
Want to DISABLE Scheduled Options, Menu Options, and Protocols? NO
==
ROUTINE: XWB2HL7
7. If the routines were unmapped as part of step 3, the mapped set
should be rebuilt once the installation has run to completion.
8. Restart the Broker Listener on the Server:
a. Log into your M server
b. Enter the following at the M prompt:
>D STRT^XWBTCP(Listener port)
(Typically, the Listener port is 9200)
During the early testing of RDV (Remote Data View), the DUZ value was hard set
============================================================================
|
